jump to navigation

Shims 13 December 2009

Posted by elfringham in volvo.
Tags: , , , , ,
trackback

10th April 2009

I have cleaned up the shims that set the end play on the rear axle. There are some either side and they fit behind the brake backing plates. I also cleaned up the spacers that go in front of the backing plates but in the process of removing the gaskets that sit either side of these spacers I damaged the paint on the backing plates. So I touched that up but now I need to get new gaskets. I also need to decide what to do about the seal carrier as they are a bit rusty, I’m just not sure what the best way of finishing them will be. Last week I continued on removing the insulating tape and then the braided cloth covering as well from the wiring loom that went to the generator. This loom runs from the generator, through the front bulkhead and along above the radiator before passing back through the bulkhead and back along the nearside wing, past the fuse box and on round to the starter motor. Curiously enough I found some disconnected wires in amongst the others. A couple of these could well have been to drive the second horn which seems to have been rewired at some point using additional wires. I’ll join those horn wires into the harness to make it a bit neater there. I think I’ll use cable ties to keep it tight around the points where wires join/leave and then the spiral binding to keep it neat.

Advertisements

Comments»

No comments yet — be the first.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: